Micro Dolphin Display Reverse Parking Sensors
Micro Dolphin Display Reverse Parking Sensors - Description
What You Get
Dolphin are proud to be first to market with a rear parking sensor kit that has a total of 6 sensors. Four to be mounted facing straight out and two sensors (A and F) that are a bit less sensitive and can be mounted to cover the side corners.
The kit comes with a dashboard mounted display that gives you a distance countdown in 10cm units until you have less that 30cm left at which point the screen will go to zero and advise you to stop. The display incorporates a buzzer which beeps with increasing frequency as you get closer to an object and there is an audio on/off switch available on the display should you wish to use it.
Kit Contents
|
How it works
The system works by radiating ultrasonic beams covering the area behind the vehicle. The beams are reflected by obstructions behind the vehicle, and re-enter the sensors. The reflected beam information is processed to calculate the distance of the obstruction.
As with the other systems the Dolphin unit is activated when reverse gear is engaged. As the vehicle is reversed. When the vehicle is less than 1.5 metres from the obstruction the audible alert will emit intermittent bleeps. As the vehicle gets closer to the obstruction the frequency of the bleeps increases. At 30 centimetres from the obstruction the bleeps become a continuous solid tone.
Stage
|
Distance
|
Awareness
|
Alarm
|
1
|
200 - 160cm
|
Safe Mode
|
No
|
2
|
150 - 100cm
|
Safe Mode
|
Bi----Bi----Bi
|
3
|
90 - 50cm
|
Alarm Mode
|
Bi--Bi--Bi
|
4
|
40 - 30cm
|
Danger Mode
|
Bi-Bi-B
|
5
|
30 - 0cm
|
Stop
|
Bi----------
|
This is an example of the display in action. If you had a post just on one side of the car the illuminated bars would vary and the shortest distance reading would be displayed. |
Swap Socket Feature All of our kits now come with the new watertight swap socket feature based 12 inches from the sensor heads, it makes installation quicker and easier. Also should you ever have a problems with faulty sensors or accident damage in the future it facilitates easy replacement without having to remove the bumper again and rewire from scratch. |
Integrated Moulded Wedges These sensors have the wedges built in, you need to position the sensors slightly angled up - or downwards, to ensure the sensor's signal is still sent out parallel with the road's surface when placed in your vehicles bumper. |
Technical Specification - Click Here
Maintenance
No routine maintenance or adjustment is required. Dirt, frost or snow accumulated on the sensors may cause the system to activate incorrectly. The sensors can be washed carefully with warm soapy water