Dolphin Red Fitted to Citroen C1 VT

 

Connecting to reversing light red wire with red scotch lock connector



Marked out sensor holes on masking tape just above the bumper

 

After drilling the sensor holes 

 

Dolphin Red sensors fitted in to holes with wires running from behind bumper 

 

Leads drawn through hole behind lamp fitting







Positioning of buzzer and control box

 

Most difficult was finding how to remove the LH rear lamp cluster then using a volt meter to find the correct wire, I didn't have a diagram nor did Halfords. I drilled very small starter holes before using the supplied hole cutter, a god send, particularly after I realized the bit needed cleaning after every hole. It took me most of 4hrs and at the end it became difficult getting up and down from the garage floor. (80 years old)